5.10 | 5.10 Clarifications to DO-254 Appendix A life cycle data | 1 |
AC | FAA AC 20-152A: scope and status | 0 |
CBA-1 | CBA-1 Circuit board assembly development process | 1 |
CD-1 | CD-1 Custom device DAL and simple or complex classification | 1 |
CD-10 | CD-10 Independent assessment of tool output | 1 |
CD-11 | CD-11 Relevant tool history | 1 |
CD-12 | CD-12 Reuse of previously developed hardware | 1 |
CD-2 | CD-2 Development process for simple custom devices | 1 |
CD-3 | CD-3 Validation of all custom device requirements | 1 |
CD-4 | CD-4 Detailed design review and design-to-requirement traceability | 1 |
CD-5 | CD-5 Review of design tool reports | 1 |
CD-6 | CD-6 Review of verification cases and procedures | 1 |
CD-7 | CD-7 Verification of implementation timing performance | 1 |
CD-8 | CD-8 Robustness: abnormal and boundary conditions as requirements | 1 |
CD-9 | CD-9 HDL code coverage criteria for elemental analysis | 1 |
COTS-1 | COTS-1 COTS device complexity assessment | 1 |
COTS-2 | COTS-2 Electronic component management process | 1 |
COTS-3 | COTS-3 Use outside manufacturer specification | 1 |
COTS-4 | COTS-4 Embedded microcode | 0 |
COTS-5 | COTS-5 Errata assessment and mitigation | 1 |
COTS-6 | COTS-6 Failure modes and common modes fed to the safety assessment | 1 |
COTS-7 | COTS-7 Definition and verification of COTS device usage | 1 |
COTS-8 | COTS-8 Critical configuration settings | 0 |
IP-1 | IP-1 Selection of COTS IP | 1 |
IP-2 | IP-2 Assessment of the COTS IP provider and data | 1 |
IP-3 | IP-3 Complementary development assurance for COTS IP | 1 |
IP-4 | IP-4 Verification strategy for COTS IP | 1 |
IP-5 | IP-5 Planning the COTS IP development assurance approach | 1 |
IP-6 | IP-6 Requirements for COTS IP functions | 1 |
IP-7 | IP-7 DO-254 Appendix B for COTS IP at DAL A and B | 1 |