1 | Scope of the document | 0 |
2 | Normative reference standards | 0 |
4.1 | Risk management to ISO 14971 | 0 |
4.10 | Leakage under pressurization | 0 |
4.11 | Leakage during aspiration | 0 |
4.12 | Female hub connector conformity | 0 |
4.13 | Gravity flow rate per lumen | 0 |
4.14 | Burst pressure during power injection | 0 |
4.15 | Packaging system to ISO 11607-1 | 0 |
4.16 | Simulated use, kink and torque strength | 0 |
4.17 | Coating integrity and particulate testing | 0 |
4.18 | Distal tip stiffness for neurovascular use | 0 |
4.2 | Usability engineering programme | 0 |
4.3 | Validated sterilization and post-sterilization conformity | 0 |
4.4 | Shelf life supported by ageing assessment | 0 |
4.5 | Visibility under X-ray or by other methods | 0 |
4.6 | Biological safety to ISO 10993-1 | 0 |
4.7 | Clean external surface and lubricant | 0 |
4.8 | Corrosion resistance of metal parts | 0 |
4.9 | Peak tensile force of catheter sections | 0 |
5.1 | Outside diameter and nominal size | 0 |
5.2 | Inside diameter and nominal size | 0 |
5.3 | Nominal effective length | 0 |
6.1 | Information supplied with the catheter | 0 |
6.2 | Device and primary packaging marking | 0 |
6.3 | Instructions for use content | 0 |
6.4 | Secondary packaging marking | 0 |
Annex-A | Corrosion resistance test | 0 |
Annex-B | Determining the peak tensile force | 0 |
Annex-C | Liquid leakage under pressure test | 0 |
Annex-D | Air leakage into hub during aspiration | 0 |
Annex-E | Determining catheter flowrate | 0 |
Annex-F | Static burst pressure test | 0 |
Annex-G | Power injection flowrate and pressure test | 0 |
Annex-H | Units outside the SI system | 0 |
Annex-I | Air leakage test under water | 0 |
Annex-J | Rationale for selected requirements | 0 |
Annex-K | Guidance on tip stiffness testing | 0 |
INTRO-Foreword | Foreword and edition history | 0 |
INTRO-Introduction | Introduction and development status | 0 |