Australia (Commonwealth, with corresponding State legislation)

Australia OGTR Guidelines for Certification of a PC2 Invertebrate Facility (Version 3.1)

84 controls. 0 other frameworks in our corpus share controls with it. Here is all of it, and how much of it you are already doing.

Page built . This page is derived from the framework corpus, which changes when the corpus is extended rather than daily.

84 controls 0 frameworks share controls with it Australia (Commonwealth, with corresponding State legislation) verified against its source document

Every control below is one this framework asks for. The right hand column counts how many other frameworks in our corpus carry the same control, which is the difference between doing this work once and doing it again for the next standard.

There is no implementation kit for this framework yet. The control list and the overlap above are free and complete.

What you already have

Frameworks whose controls overlap this one, most first. If you run any of them, the count is roughly what you have already evidenced.

No measured overlap with another framework in the corpus.

Every control

CodeControlAlso in
A0Purpose of the guidelines and how certification works0
A1Enclosable and securable space0
A10Hand decontamination0
A11Eyewash for Risk Group 2 micro-organism dealings0
A12Containment of aerosols0
A13Backflow: facility already meets AS/NZS 2243.30
A14Backflow assessment where AS/NZS 2243.3 is not met0
A15Place for reusable personal protective equipment0
A16Stopping animals passing through the anteroom0
A17Invertebrate trap in the work area0
A18Ability to meet the conditions of certification0
A19Floor plans with the application0
A2Surfaces impenetrable or decontaminable0
A3Sealed structural joints0
A4Screened or filtered openings0
A5Dedicated anteroom0
A6Other spaces acting as the anteroom for uninfected Drosophila0
A7Self-closing access doors that prevent escape0
A8Barriers on drainage exits0
A9Open spaces reachable for decontamination0
ATT1Standards referenced (Attachment 1)0
B0Status of the Part B conditions0
B1Access limited to authorised persons0
B10Work not allowed in a PC2 invertebrate facility0
B11Notifying the Regulator when an owner fails to maintain0
B12Inspection at least every 12 months0
B13Signs at each access door0
B14Decontaminants available, labelled and in date0
B15Control of pests and escaped invertebrates0
B16Keeping the Part A requirements met0
B17Before structural changes0
B18Lifting a suspension0
B19Testing biological safety cabinets0
B2Who counts as an authorised person0
B20Test certificate on the cabinet0
B21Cabinet that fails its test0
B22Monthly monitoring and annual calibration of heat-based decontamination0
B23Users can see the decontamination equipment status0
B24Defective decontamination equipment0
B25Maintaining backflow prevention measures0
B26Backflow assessment where none was done before0
B27Reviewing the backflow assessment0
B28Fitting backflow prevention after a review0
B29Keeping the backflow records0
B3Training records on the Regulator's request0
B30Annual testing of testable backflow devices0
B31Faulty backflow device0
B4Excluding a person on the Regulator's direction0
B5Conditional admission on the Regulator's direction0
B6Telling people their admission conditions0
B7Submissions on exclusion or conditional admission0
B8Authority to admit and exclude where the holder is not the owner0
B9Entry for the Regulator0
C1Who must follow the behavioural requirements0
C10Using and decontaminating cabinets0
C11Protective clothing and gloves for GM micro-organism dealings0
C12Checking for invertebrates before leaving0
C13Removing protective equipment before leaving0
C14Wearing protective equipment between facilities0
C15Decontamination methods0
C16Trained people decontaminate0
C17Decontaminate before disposal0
C18Decontaminating benches and equipment after work0
C19Decontaminating equipment before it leaves0
C2Non-GMO, exempt and PC1 work in the facility0
C20Removing and treating contaminated protective equipment0
C21Hand decontamination on leaving0
C22Escaped invertebrate inside the facility0
C23Written spill procedures0
C24Dealing with a spill inside0
C25Escape or loss outside the facility0
C26Decontamination to the guidelines0
C27Identifying GM invertebrates and material0
C28Transport and storage outside the facility0
C29Sealed storage of cultures0
C3Entry and exit through the anteroom0
C30No dealings in the anteroom0
C4Emergency exits0
C5Doors closed and secured0
C6Windows closed and secured0
C7Handling invertebrates to limit escape and exposure0
C8Containers or cages when not being handled0
C9Aerosol-generating work in a cabinet0
DEFDefinitions and acronyms0

Tell me when Australia OGTR Guidelines for Certification of a PC2 Invertebrate Facility (Version 3.1) files something new

One email when a public company newly discloses something this framework governs, naming the company and what our corpus says it puts in scope. Nothing else, and one click to stop.

What this page is

A control-level reference for Australia OGTR Guidelines for Certification of a PC2 Invertebrate Facility (Version 3.1), drawn from our framework corpus. Control codes and titles are references to the standard, not reproductions of it. The overlap counts and the auditor artefacts are our own work and are the part you will not find elsewhere.

Measure this against what you already run · All frameworks · Today's edition