Australia (all Rail Safety National Law jurisdictions)

Australia National Standard for Health Assessment of Rail Safety Workers 2024

40 controls. 0 other frameworks in our corpus share controls with it. Here is all of it, and how much of it you are already doing.

Page built . This page is derived from the framework corpus, which changes when the corpus is extended rather than daily.

40 controls 0 frameworks share controls with it Australia (all Rail Safety National Law jurisdictions) verified against its source document

Every control below is one this framework asks for. The right hand column counts how many other frameworks in our corpus carry the same control, which is the difference between doing this work once and doing it again for the next standard.

There is no implementation kit for this framework yet. The control list and the overlap above are free and complete.

What you already have

Frameworks whose controls overlap this one, most first. If you run any of them, the count is roughly what you have already evidenced.

No measured overlap with another framework in the corpus.

Every control

CodeControlAlso in
2.1Establish a health risk management system: set the level and frequency of health assessment for each rail safety worker according to the risk of the tasks they perform, in the cont0
2.2.1Risk categories: classify each task as Safety Critical Work where ill-health could lead directly to a serious incident affecting the public or the network, splitting it into Catego0
2.2.2Match assessments to categories and add task-specific requirements: Category 1 and 2 Safety Critical Workers receive a Health Questionnaire and clinical examination screening for c0
2.2.5Drug and alcohol testing interface: Pre-placement or change of category assessments may include a drug or alcohol test depending on jurisdiction and operator policy, Periodic Healt0
2.2.6Timing and frequency: Pre-placement or change of risk category assessments before Category 1, 2 or 3 work begins or a worker moves to a higher category; Periodic Health Assessments0
2.2.7Validity of certificates and scheduling: no worker performs rail safety work without a current fitness for duty report; reports expire at the end of the period stated and must be d0
2.3Standard reporting framework: adopt the four outcomes, Fit for Duty Unconditional, Fit for Duty Subject to Review (including Subject to Job Modification for incumbents and provisio0
2.4Risk categorisation process: follow the nine steps, define the context, identify rail safety tasks, analyse tasks into activities including rare emergency activities, analyse exist0
2.5Authorising health professionals: use only Authorised Health Professionals registered with the AHP Program, who hold the required qualifications (AHPRA-registered medical practitio0
2.6.1Scheduling and notification: keep a database of each worker's category, assessment type, due dates for periodic and triggered assessments and any restrictions, managed under privac0
2.6.2Forms and identification: use the model forms, the Request and Report Form (operator to health professional and back, functional findings only), the Worker Notification and Health 0
2.6.4Communicating with workers: inform workers of their obligations and protections under the Standard and the law, alert them to assessment requirements and status, and after any outc0
2.6.5Communicating with health professionals: before each assessment provide all forms and supporting information, the previous assessment report and, where relevant, changes in sick le0
2.6.6Managing health information: comply with the Australian Privacy Principles and health records law; collect only information needed to assess fitness for duty and tell workers why, 0
2.7Quality control: implement a formal, risk-based quality control system confirming that workers are correctly categorised, receive the assessments the Standard requires, that assess0
3.1Appointments, consultation and documentation: assessments are conducted in person, with telemedicine excluded except where an exemption under section 203 or 203A of the Rail Safety0
3.2Tests and equipment: for Pre-placement, change of category and Periodic assessments obtain a resting ECG and non-fasting cholesterol (total and HDL) and HbA1c for Category 1, a uri0
3.3Orienting the worker: accommodate gender, cultural and language needs; before starting explain the purpose and that results will be discussed, explain how information will be colle0
3.4The examination: identify health issues, assess their impact on rail safety work with investigation or specialist referral as needed, apply the fitness for duty criteria and manage0
3.4.8Drugs and rail safety work: under the Rail Safety National Law a worker must not perform rail safety work with any alcohol or prescribed drug (THC, methamphetamine, MDMA and others0
3.5Additional tests and referral: use functional or practical assessments only to supplement where the Standard is imprecise, aware they are a snapshot, may injure a worker not fit to0
3.6Reporting and record keeping: report fitness using only the four standard classifications; phone the operator immediately when a worker is temporarily or permanently unfit, discuss0
3.7Communicating with the worker and treating professionals: advise the worker of the results and how their condition may impair rail safety work, helping them understand control, rev0
4.1Blackouts: unpredictable loss of consciousness is incompatible with Category 1 work; assess both Category 1 and 2 workers who have had a blackout as Temporarily Unfit for Duty unti0
4.10Psychiatric conditions: assess fitness individually on the specific pattern of illness, potential impairments and severity rather than diagnosis, for conditions including schizophr0
4.11Sleep disorders: assess sleep apnoea and other sleep disorders, and fatigue presentations, at Periodic and Triggered assessments using the Epworth Sleepiness Scale and the STOP-Ban0
4.12Substance misuse and dependence: assess Category 1 and 2 workers for misuse of any substance that impairs cognition, including chronic heavy alcohol use, misuse of prescription and0
4.13Vision and eye disorders: assess visual acuity, visual fields, monocularity, progressive eye conditions such as cataract, glaucoma and diabetic retinopathy, and colour vision accor0
4.2Cardiovascular conditions: identify, assess and manage cardiovascular disease that could cause sudden incapacity (Category 1) or impair concentration and control through chest pain0
4.3Diabetes: screen Category 1 workers by non-fasting HbA1c at every assessment (below 48 mmol/mol or 6.5 per cent not diabetic; 53 mmol/mol or 7 per cent and above diabetic; intermed0
4.4Hearing: apply the Standard to Safety Critical Workers according to the task-specific requirement to hear speech in noise or in quiet, assuming closed-loop safety critical communic0
4.5Musculoskeletal disorders: assess each worker's capacity against the inherent musculoskeletal requirements of their tasks as the operator has defined them (limb, neck and back soun0
4.6Neurological conditions, general and dementia: examine neurological function needed for situational awareness and emergency response (alertness, attention, memory, judgement, sensa0
4.7Seizures and epilepsy: any seizure with loss of awareness or motor control can impair both categories of Safety Critical Work; manage a worker who has had a seizure under the Stand0
4.8Other neurological conditions: assess the effect on cognition, vision, sensation, motor function and balance of conditions including vestibular disorders and vertigo, unruptured in0
4.9Neurodevelopmental disorders: assess ADHD, autism spectrum disorder, disorders of intellectual development and traits at the extreme of neurodiversity for their effect on attention0
5Category 3 Track Safety Health Assessment: assess hearing (ability to hear a train horn, with aided audiometry on the better ear, discrimination-in-noise testing and job modificati0
ROLESWho does what: the NTC maintains and reviews the Standard, ONRSR regulates and audits compliance, RISSB coordinates the Chief Medical Officers Council and the Authorised Health Pro0
SCOPEWhat the Standard is: the national standard, approved under the Rail Safety National Law, that rail transport operators must apply when assessing the health and fitness of rail saf0
TOOLSClinical tools, model forms and transition: the Clarke hypoglycaemia awareness questionnaire, K10, Epworth Sleepiness Scale, STOP-Bang and AUDIT are the supporting tools; the model0

Tell me when Australia National Standard for Health Assessment of Rail Safety Workers 2024 files something new

One email when a public company newly discloses something this framework governs, naming the company and what our corpus says it puts in scope. Nothing else, and one click to stop.

What this page is

A control-level reference for Australia National Standard for Health Assessment of Rail Safety Workers 2024, drawn from our framework corpus. Control codes and titles are references to the standard, not reproductions of it. The overlap counts and the auditor artefacts are our own work and are the part you will not find elsewhere.

Measure this against what you already run · All frameworks · Today's edition