Australia (model for the harmonised WHS jurisdictions: Commonwealth, NSW, Qld, SA, WA, Tas, ACT, NT; not Victoria)

Australia Model Code of Practice: Construction Work

54 controls. 1 other frameworks in our corpus share controls with it. Here is all of it, and how much of it you are already doing.

Page built . This page is derived from the framework corpus, which changes when the corpus is extended rather than daily.

54 controls 1 frameworks share controls with it Australia (model for the harmonised WHS jurisdictions: Commonwealth, NSW, Qld, SA, WA, Tas, ACT, NT; not Victoria) verified against its source document

Every control below is one this framework asks for. The right hand column counts how many other frameworks in our corpus carry the same control, which is the difference between doing this work once and doing it again for the next standard.

There is no implementation kit for this framework yet. The control list and the overlap above are free and complete.

What you already have

Frameworks whose controls overlap this one, most first. If you run any of them, the count is roughly what you have already evidenced.

If you runShared controls
ISO 45001:201835measure it →

Every control

CodeControlAlso in
1.51.5 Every construction project has one principal contractor, properly authorised (r 293)1
1.61.6 Multiple and shared duties: each duty holder complies, no contracting out1
1.7a1.7 Manage construction risks, physical and psychosocial, through the hierarchy of control (rr 297, 32 to 38)1
1.7b1.7 Consult workers at every step of risk management (ss 47, 48)1
1.7c1.7 Consult, cooperate and coordinate with other duty holders on site (s 46)1
2.1a2.1 Designers give the commissioning PCBU a written safety report on design-specific construction hazards (r 295)0
2.1b2.1 Persons who commission construction work consult the designer and pass on hazard information (rr 294, 296)1
2.1c2.1 Principal contractor site signage (r 308)0
2.1d2.1 Secure the construction workplace from unauthorised access (r 298)0
2.1e2.1 Obtain and provide underground essential services information before excavation (r 304)1
2.1f2.1 Manage excavation risks and support trenches of 1.5 metres or more (rr 305, 306)0
2.1g2.1 Officers exercise due diligence over construction WHS (s 27)1
2.22.2 Workers' duties, including keeping the white card available for inspection1
2.32.3 Other persons at the site: reasonable care and compliance with instructions0
3.13.1 Identify physical and psychosocial construction hazards1
3.23.2 Assess risks where it helps decide controls1
3.3a3.3 Eliminate construction risks, then minimise by substitution, isolation and engineering1
3.3b3.3 Administrative controls and PPE only after higher controls, or to add protection1
3.3c3.3 Combine controls and check the combination introduces no new risk1
3.43.4 Maintain and review controls, and revise the SWMS and WHS management plan with them (rr 37, 38)1
4.14.1 Prepare a SWMS before high risk construction work starts, and coordinate who prepares it (r 299)1
4.2a4.2 SWMS content: specific controls, accessible, workplace specific, generic versions reviewed1
4.2b4.2 Consult workers and HSRs when preparing and reviewing a SWMS1
4.2c4.2 Construction projects: SWMS reflects the WHS management plan and reaches the principal contractor first (rr 301, 312)0
4.3a4.3 Ensure work follows the SWMS; stop work when it does not (r 300)1
4.3b4.3 Make the SWMS readily accessible and instruct workers on it1
4.3c4.3 Keep the SWMS until the work is complete, or 2 years after a notifiable incident (r 303)1
4.44.4 Review and revise the SWMS with workers when controls change (r 302)1
5.25.1 and 5.2 Prepare a written WHS management plan before the project starts, with the required content (r 309)1
5.35.3 Generic WHS management plans reviewed for each project1
5.45.4 Make everyone doing the work aware of the plan and their right to inspect it (r 310)1
5.55.5 Review the plan to keep it current and tell people of revisions (r 311)1
5.65.6 Keep the plan until project completion, or 2 years after a notifiable incident (r 313)1
66 Provide information, training, instruction and supervision for construction work (r 39)1
6.1a6.1 General construction induction training before construction work (rr 316, 317)1
6.1b6.1 Ensure each construction worker holds a white card or certification (rr 317, 319)1
6.26.2 Workplace specific induction training1
6.36.3 Task-specific training developed and kept current0
6.46.4 Supervision by trained and authorised supervisors1
7a7 Principal contractor arranges compliance with the general workplace duties (r 314)0
7b7 Principal contractor manages materials, stored plant, traffic and essential services risks (r 315)1
DAppendix D: Designers' duties for structures (WHS Act s 22 and r 295)0
K-envAppendix J and K: Work environment, entry and exit, work areas, floors, lighting and heat (r 40)0
K-epAppendix J and K: Prepare, maintain, test and implement an emergency plan (r 43)1
K-faAppendix J and K: First aid equipment, facilities and trained first aiders (r 42)1
K-facAppendix J and K: Provide and maintain adequate, accessible facilities (r 41)0
K-foAppendix J and K: Manage falling object risks: prevent free fall, otherwise arrest it (rr 54, 55)0
K-ppeAppendix J and K: Provide, select and use personal protective equipment (rr 44 to 47)0
K-riAppendix J: Remote or isolated work (r 48)0
approvalsEdition, amendments and jurisdictional approvals0
appx-templatesAppendices E, F, H and I: SWMS and WHS management plan templates and samples0
defs-1.1-1.51.1 to 1.5 What is construction work, a structure, high risk construction work and a construction project0
scopeScope, application and housing construction guidance0
statusLegal status: an approved code is admissible evidence, not law0

Tell me when Australia Model Code of Practice: Construction Work files something new

One email when a public company newly discloses something this framework governs, naming the company and what our corpus says it puts in scope. Nothing else, and one click to stop.

What this page is

A control-level reference for Australia Model Code of Practice: Construction Work, drawn from our framework corpus. Control codes and titles are references to the standard, not reproductions of it. The overlap counts and the auditor artefacts are our own work and are the part you will not find elsewhere.

Measure this against what you already run · All frameworks · Today's edition