Australia and New Zealand

AS/NZS 4801:2001 Occupational Health and Safety Management Systems (superseded edition)

32 controls. 0 other frameworks in our corpus share controls with it. Here is all of it, and how much of it you are already doing.

Page built . This page is derived from the framework corpus, which changes when the corpus is extended rather than daily.

32 controls 0 frameworks share controls with it Australia and New Zealand verified against its source document

Every control below is one this framework asks for. The right hand column counts how many other frameworks in our corpus carry the same control, which is the difference between doing this work once and doing it again for the next standard.

There is no implementation kit for this framework yet. The control list and the overlap above are free and complete.

What you already have

Frameworks whose controls overlap this one, most first. If you run any of them, the count is roughly what you have already evidenced.

No measured overlap with another framework in the corpus.

Every control

CodeControlAlso in
4.1Establish and maintain an OHSMS that meets Section 40
4.2Top management authorises an OHS policy with the six required commitments0
4.3Planning0
4.3.1Documented procedures and an up-to-date methodology for hazard identification, assessment and control0
4.3.2Identify, access, keep current and communicate legal and other OHS requirements0
4.3.3Set documented OHS objectives and targets at each relevant function and level0
4.3.4Maintain OHS management plans with responsibilities, means and timeframes, reviewed on change0
4.4Implementation0
4.4.1.1Management identifies and provides the resources the OHSMS needs0
4.4.1.2Define, document and communicate OHS accountabilities and appoint a management representative0
4.4.2Identify training needs with employees, assess competence and deliver OHS training by qualified people0
4.4.3.1Agreed, documented procedures for employee involvement and consultation on OHS0
4.4.3.2Procedures for two-way OHS communication with employees and interested parties0
4.4.3.3Reporting procedures covering performance, incidents, hazards, assessments, corrective action and statutory reports0
4.4.4Maintain information describing the OHSMS core elements, their interaction and related documents0
4.4.5Control documents and data: locatable, reviewed, current at points of use, obsolete removed, archives identified0
4.4.6.1Documented procedures ensure hazard identification, assessment, control and evaluation are carried out0
4.4.6.2Hazard identification covers causes, nature of harm, history and the full life cycle of work0
4.4.6.3Assess all risks (Australia) or hazards (New Zealand) and assign control priorities0
4.4.6.4Control risks through a hierarchy based on reasonable practicability, elimination first0
4.4.6.5Documented evaluation of the effectiveness of hazard identification, assessment and control0
4.4.7Identify potential emergencies, document, review after incidents and periodically test the procedures0
4.5Measurement and evaluation0
4.5.1.1Monitor and measure key OHS characteristics, calibrate equipment, and monitor performance and legal compliance0
4.5.1.2Identify where health surveillance is required, implement it, give employees their results and record legislated monitoring0
4.5.2Investigate incidents and system failures, take corrective and preventive action, and record the resulting changes0
4.5.3Identify, maintain and dispose of OHS records so they are legible, traceable, retrievable, protected and retained for set periods0
4.5.4Run a risk-based OHSMS audit program with competent auditors and report results to management and employees0
4.6Top management reviews the OHSMS at set intervals, documents it and changes policy, objectives and elements as needed0
appendicesAppendices A to C: guidance on the specification, correspondence tables and bibliography0
scopeScope, referenced documents and definitions (Sections 1 to 3)0
statusStatus: superseded by AS/NZS ISO 45001:2018, kept as a historical edition0

Tell me when AS/NZS 4801:2001 Occupational Health and Safety Management Systems (superseded edition) files something new

One email when a public company newly discloses something this framework governs, naming the company and what our corpus says it puts in scope. Nothing else, and one click to stop.

What this page is

A control-level reference for AS/NZS 4801:2001 Occupational Health and Safety Management Systems (superseded edition), drawn from our framework corpus. Control codes and titles are references to the standard, not reproductions of it. The overlap counts and the auditor artefacts are our own work and are the part you will not find elsewhere.

Measure this against what you already run · All frameworks · Today's edition